<< Go Back To Index
Drawers (Initial Values)
These initial values will setup your drawer banks and the top drawer opening in your base cabinets to the entered values. Use whatever values you most commonly use. There will be ways to modify this later in the program. At this point we are just looking for the numbers you will most often be using in this job.
- Number in Standard Drawer Bank: Enter the total number of drawers you want in a single standard drawer bank. (The drawers below the top drawer will be evenly spaced.)
- Number in Vanity Drawer Bank: Enter the total number of drawers you want in a single standard Vanity. (The drawers below the top drawer will be evenly spaced.)
- Top Drawer Opening for Standard Base: Enter the opening height for the top drawer in a standard base. This is the distance between the bottom of the top rail and the top of the uppermost center rail.
- Top Drawer Opening for Vanity Base: Enter the opening height for the top drawer in a Vanity. This is the distance between the bottom of the top rail and the top of the uppermost center rail. NOTE: This particular standard can be changed in Edit Elevations by adjusting this standard in Cabinet Standards.
NOTE: The proceeding 4 drawer standards can be changed later in the Edit Elevations screen by adjusting it using the Edit Openings feature.